Happymodel Mobula7 V2 75mm Crazybee F3 Pro OSD 2S Whoop FPV Racing Drone w/ Upgrade BB2 ESC 700TVL BNF

Happymodel Mobula7 V2 75mm Crazybee F3 Pro OSD 2S Whoop FPV Racing Drone w/ 700TVL Camera BNF Click here to buy Original Mobula7 Parts. Specification: Brand Name: Happymodel Model: Mobula7 V2 Item Name: 75mm Wheelbase 2S Brushless Whoop FPV Racing Drone Wheelbase: 75mm Version: Basic Version / Standard Version ( Optional) - The diffirence of them are the package charger. Basic Version: USB Charger Standard Version: 6-way Charger Receiver ( Optional): Compatible Frsky NON-EU Receiver Compatible Frsky EU-LBT Receiver ( XM+ Receiver) Compatible Flysky AFHDS/ AFHDS-2A Receiver Compatible DSM2/DSMX Receiver Size: 98mm*98mm*36mm Weight: 25.9g (without battery) Take Off Weight: about 44g Crazybee F3 Pro Flight Controller Item Name: Crazybee F3 Pro FC MCU: STM32F303CCT6 (72MHZ, 256K FLASH) Sensor: MPU-6000(SPI connection) Board size: 28.5 * 28.5MM Power supply: 1-2S battery input (DC 3.5-8.7V) Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready Built-in Receiver ( Diffirent version having diffirent receiver) Built-in Betaflight OSD(SPI Control) Built-in Current meter Max 28A Current meter scale set to 1175 Built-in 5V 1A BEC with LC filter Built-in voltage detection BLHELI_S pass-through Ready Heading LED Ready Firmware (Frsky version) CRAZYBEEF3 PRO FR Firmware target: CrazybeeF3FR (Flysky version) CRAZYBEEF3 PRO FS Firmware target: CrazybeeF3FS (DSM2/DSMX version) CRAZYBEEF3 PRO Firmware target: CrazybeeF3DX (Frsky EU-LBT version) CRAZYBEEF3 PRO FS Firmware target: CrazybeeF3FS Onboard 5A 4 In 1 ESC Power supply: 1-2S LiPo/LiPo HV (3.5v/8.7v) MCU upgraded to EFM8BB21 Current: 5A continuous peak 6A (3 seconds) Support BLHeliSuite programmable Factory firmware: S_H_50_REV16_7 Default protocol: DSHOT600 Onboard Frsky NON-EU receiver Version SPI BUS receiver Frsky D8/D16 switchable Compatible Non EU transmitter both D8 and D16 mode Channels: 8ch or 16ch Failsafe support No ground interference ( Transmitter and receiver 1 m from the ground): 300m Onboard Frsky EU-LBT Version (External XM+ receiver) Operating Voltage Range: 3.7~10V Operating Current: 30mA @5V Operating Range: Full range With RSSI output on board: Analog 0~3.3V Firmware Upgradeable, Default firmware EU-LBT with RSSI Onboard Flysky receiver Version SPI BUS receiver Protocol: AFHDS and AFHDS-2A Switchable Channels: 8ch(AFHDS) or 14ch(AFHDS-2A) Failsafe support No ground interference ( Transmitter and receiver 1 m from the ground): 300m Onboard DSM2 / DSMX receiver version Serial bus receiver Protocol: DSM2/DSMX compatible Channels:6-9 (Depend on your radio) No ground interference ( Transmitter and receiver 1 m from the ground): 300m SE0802 16000KV Motor Model: SE0802 KV: 16000KV Configu-ration: 9N12P Stator Diamter: 8mm Stator Length: 2mm Shaft Diameter: 1.0 Motor Dimension (Dia.*Len) : 10.5*14.5mm Weight: 1.8g Support 1-2S Lipo No.of Cells: 1S Lipo Propeller 40mm 4-blade Propeller ( 4 CW + 4 CCW) 5.8G VTX AIO Camera 5.8G 40CH 25mW VTX Output power: 25mw Frequency: 40CH Input voltage: 3.3V 5.5V Current consumption: 300mA(type) 700TVL FOV120 Camera Camera resolution: 700TVL Field of view: 120 Video Format: NTSC Antenna: RG178 antenna Frequency: 5.8GHz 5bands 40 channels With Raceband Smartaudio ready(Frsky EU-LBT and DSMX version not compatible) Size: 13.9"12.0mm ( L*W ) Weight: 3g Lipo Battery Capacity:250mAh Voltage:3.8v Continuous Discharge Rate: 30C Instantaneous discharge rate: 60C Size: 55mmx12mmx7mm Weight: 6.5g Connector: PH2.0 Notes: Need 2pcs batteries for Series circuit Features: - New Crazybee F3 PRO Flight controller 1-2s Lipo compatible - 2S whoop more powerful and more flight time - Betaflight support multi flight mode: ACRO/AIR/ANGLE - New 0802 Powerful and High efficiency Brushless motor and Smooth ESC - Smartaudio ready change VTX bands, channels via OSD DSM2/DSMX and Frsky EU-LBT version are Serial-based receiver, so Smartaudio is not compatible. - Adjust the settings and the PID of the flight controller via OSD - Frsky Non-EU version support NON-EU Frsky transmitter D8/D16 compatible - Flysky version support both AFHDS and AFHDS-2A protocol transmitter - DSM2/DSMX version support DSM2 and DSMX compatible Spektrum transmitter - Frsky EU-LBT version support Frsky EU-LBT firmware transmitter - Full telemetry function ready - Head lights ready - Camera angle adjustable - Real Bind and Fly version - Buzzer Ready Package Included: Basic Version 1x Mobula7 V2 75mm FPV Drone 4x 40mm 3-Blade Propellers ( 4 CW & 4 CCW) 4x 3.8v 250mah 30C/60C Lipo battery 1x USB Lipo/LIHV Charger 1x Fixing Mount for Lipo Battery 1x Propeller Disassemble Tool 1x Screwdriver Standard Version 1x Mobula7 V2 75mm FPV Drone 4x 40mm 3-Blade Propellers ( 4 CW & 4 CCW) 4x 3.8v 250mah 30C/60C Lipo battery 1x 1S06 6 Way Lipo/LIHV charger 1x Propeller Disassemble Tool 1x Fixing Mount for Lipo Battery 1x Screwdriver