F5 V1.1 Based on ATMEGA 2560 Replace MKS BASE & Ramps 1.4 Control Board +3.5inch WiFi LCD Touch Screen for 3D Printer

Motherboard Descriptions The F5V1 1 is a compact practical and flexible control panel It is based on Mega2560 single board solution higher stability support plug and play saving research and development familiarity and installation time F5V1 1 has the high expansibility facilitates the developer debugging enhances the development cycle Features 1 Operating Voltage 19 24V MAX 10A2 MASTER IC atmega256016au3 FT232RL USB interface4 Integrated 5 A5984 stepper motor drive5 Two heating ends support two color printing maximum temperature depends on the hot head material 6 The Circuit Board is made of 4 layers of high qualityKill Using a chip type fuse and Mosfet Tube a total of 4 MOSFET tubes one of which is used for heating the bed8 24V power supply outlets are equipped with 5A 10A and 15A recoverable fuse protection9 There are two power inlets and the hot bed is powered separately10 Based on ArduinoPlatform support a variety of firmware a variety of PC softwareInterface resource description ●3 channel ADC interface is available for temperature measurement Two extruders and one hotbed●1 way PWM 1 Control Fan●Road Limit Switch X Y Z can be connected to the machine●There are two external power interfaces one for direct access from the power socket and one for PWR IN and BED INTAP into the power●Direct steering gear controlled by single chip microcomputer●The three control feet of stepping motor are adjustableSoftware Resources Compile Environment