Eachine RedDevil V2 105mm 2-3S FPV Racing Drone Whoop PNP/BNF Crazybee F4 PRO Caddx EOS2 5.8G 25~200mW Nano VTX (28off coupon: 28rc)

28off coupon: 28rc Eachine RedDevil V2 105mm 2-3S FPV Racing Drone Whoop Crazybee F4 PRO Caddx EOS2 5.8G 25~200mW Nano VTX Note: The propeller has been upgraded to HQprop 65mm to solve the problem of shaking during flight. Specifications: Brand Name: Eachine Item Name: RedDevil V2 2-3S Micro FPV racing drone Wheelbase: 105mm Size: 95mm*95mm*50mm(without propellers) Weight: 37.4g(without battery) Weight:63.2g(with Original 3s 300mah Lipo battery ) Spare parts specifications: Motor Mode: EX1102 KV8700 Configu-ration:9N12P Stator Diamter:11mm Stator Length:2mm Shaft Diameter:1.5mm Motor Dimension(Dia.*Len):13.5mm*16mm Weight(g):2.8g No.of Cells(Lipo):2S-3S Flight controller (Frsky version) CRAZYBEE F4FR PRO V2.1 Firmware target: CrazybeeF4FR (Flysky version) CRAZYBEE F4FS PRO V2.1 Firmware target: CrazybeeF4FS (DSM2/DSMX version) CRAZYBEE F4DX PRO V2.1 Firmware target: CrazybeeF4DX (No RX version) CRAZYBEE F4 PRO V2.1 Firmware target: CrazybeeF4DX MCU:STM32F411CEU6 (100MHZ, 512K FLASH) Sensor: MPU-6000(SPI connection) Board size: 28.5 * 28.5MM Power supply: 2-3S battery input (DC 7.4-13V) Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready Frsky version Built-in SPI Frsky receiver with telemetry(D8/D16 switchable) Flysky version Built-in SPI Flysky receiver with telemetry(AFHDS/AFHDS2A switchable) DSM2/X Version built-in Serial-based DSM2/DSMX compatible satellite receiver No RX version need to add external Receiver Built-in Betaflight OSD(SPI Control) Built-in Current meter Max 28A Current meter scale set to 1175 Built-in 5V 1A BEC with LC filter Built-in voltage detection Onboard 4in1 ESC MCU upgraded to EFM8BB21 Power supply: 2-3S LiPo/LiPo HV (7.4v/13v) Current: 5A continuous peak 6A (5 seconds) Support BLHeliSuite programmable Factory firmware: S_H_50_REV16_7.Hex Default protocol: DSHOT600 Frsky receiver Version SPI BUS receiver Frsky D8/D16 switchable Compatible both Non EU and EU-LBT transmitter Channels: 8ch or 16ch EU-LBT support(need to update betaflght v4.0 date 2019-04-11) Failsafe support No ground interference ( Transmitter and receiver 1 m from the ground): 300m Flysky receiver Version SPI BUS receiver Protocol: AFHDS and AFHDS-2A Switchable Channels: 8ch(AFHDS) or 14ch(AFHDS-2A) No ground interference ( Transmitter and receiver 1 m from the ground): 300m Failsafe support DSM2/DSMX receiver version Serial bus receiver Protocol: DSM2/DSMX compatible Channels:6-9 (Depend on your radio) No ground interference ( Transmitter and receiver 1 m from the ground): 300m PNP No RX version No RX version support external serial-bus receiver like xm+ crossfire, S-FHSS etc. VTX Output power: 25~200mw switchable Frequency: 40CH Input voltage: 3.3V 5.5V Current consumption: 300mA(type) Antenna: RG178 antenna Frequency: 5.8GHz 5bands 40 channels With Raceband Smartaudio ready Weight: 2g CADDX EOS2 camera 1/3" CMOS Sensor 1200 TVL 2.1mm lens 16:9 Image size NTSC Global WDR Internal Synchronization Lipo Battery Capacity:300mAh Voltage:11.4v Continuous Discharge Rate: 30C Instantaneous discharge rate: 60C Size: 65mmx18mmx11mm Weight: 25g Connector: XT30 Features: Crazybee F4 PRO V2.1 AIO Flight controller 2-3s Lipo Compatible The lightest 1102 brushless motor only 2.8g with double ball bearings Light ,Powerful and smoothly Caddx EOS2 ready Camera angle adjustable 25mw-200mw 5.8g vtx with smartaudio Betaflight OSD support ,easy to get RSSI, Voltage ,current from your goggles(DSMX version no RSSI output) Frsky version support both NON-EU and EU-LBT Frsky transmitter(EU-LBT need to update firmware to Betaflight 4.0( release date :2019-4-11) Flysky version support both AFHDS and AFHDS-2A protocol transmitter DSM2/DSMX version support DSM2 and DSMX compatible Spektrum transmitter No RX version support external serial-bus receiver like xm+ crossfire, S-FHSS etc.. Full telemetry function ready (Frsky and Flysky version support) Real Bind and Fly version Package Included: 1 x 105mm Brushless whoop Frame 1 x Adjustable angle canopy 1 x Option1: Crazybee F4FR V2.1 PRO FC built-in Frsky RX Option2: Crazybee F4FS V2.1 PRO FC built-in Flysky RX Option3: Crazybee F4DX PRO V2.1 FC built-in Serial-bus DSM2/DSMX RX Option4: Crazybee F4 V2.1 PRO FC no RX verion 4 x EX1102 KV8700 Motor 1 x HQprop 65mm red propeller(6xcw+6xccw) 1 x Caddx EOS2 camera 1 x 5.8g 25mw-200mw Nano VTX 1 x 3S 11.4v 300mah 30C/60C battery 1 x XT30 Plug Pigtail Power Wire with 100F 16V Capacitor 1 x Propeller disassemble tool 1 x Screwdriver 1 x Eachine Handbag