10pcs MQ-135 Ammonia Sulfide Benzene Vapor Gas Sensor Module Shield Liquefied Electronic Detector Module For arduino

10pcs MQ-135 Ammonia Sulfide Benzene Vapor Gas Sensor Module Shield Liquefied Electronic Detector Module For arduino
Eachine1
sku: 1384518
ACCORDING TO OUR RECORDS THIS PRODUCT IS NOT AVAILABLE NOW
$19.09
Shipping from: China
   Description
Features : - Sensitive material MQ135 gas sensor is used in clean air low conductivity tin oxide (SnO2). When the sensor is kept in their environment In the polluting gases the conductivity sensor with increasing air pollution in gas concentration increases. - Using a simple circuit can change the conductivity Conversion of an output signal corresponding to the gas concentration . - MQ135 sensor for ammonia, sulfide benzene vapor high sensitivity of the smoke and other harmful monitor is also very good. This sensor can be seized measure a variety of harmful gases is a low-cost sensors for a variety of applications . Speciffications: 1. It adopts high quality double panel design with power indication and TTL signal output indication; 2. It has DO switch signal (TTL) output and AO analog signal output; 3. The TTL output valid signal is low. (When the output is low, the signal light is on, it can be directly connected to the MCU or relay module) 4. The voltage of the analog output, the higher the concentration, the higher the voltage. 5. It has good sensitivity to gas and natural gas detection. 6, there are four screw holes for easy positioning; 7, product dimensions: 32 (L) * 20 (W) * 22 (H) 8, has a long service life and reliable stability 9, fast response recovery characteristics Electrical Performance: Dection of gas: Ammonia /Sulfide/ Benzene vapor Dection of Concentration:10-1000ppm Input voltage: DC5V Power consumption (current): 150mA DO output: TTL digital quantities 0 and 1 (0.1 and 5V) AO output: 0.1-0.3V (relatively non-polluting) the highest concentration voltage is about 4V Using the chip: AT89S52 Crystal: 11.0592MHZ Baud rate: 9600 Compilation environment: Keil Special Reminder: After the sensor is energized, it needs to be preheated for about 20S, and the measured data is stable. The heating of the sensor is a normal phenomenon, because there is a heating wire inside, if it is hot, it is not normal. Package Included: 10 x MQ-135 Gas Sensor Module
   Price history chart & currency exchange rate

Customers also viewed