Wooden Dead Eyes Mooring Tool Fix Tools for Wood Ship Model Kit

Description Wooden Dead Eyes Mooring Tools Fix Tool for Wood Ship Model KitSpecification Material WoodenSize 70x55x7mmFeatures This tool can made the mooring cables work become simple and feasible This tool can adjust the distance between mooring cables in a control range The diameter range of the three eye pulley which can be installed auxiliary is 3 5mm 10mm and the distance between the upper and lower three eye pulley mooring cable is 10mm 30mm This tool is a kit you need also assembly Installation Steps Combine 1 and 2 part with glue and fix with Screw First determine the distance between the top and bottom of the three eye pulley set you are going to make and the actual distance of the blue arrow point to the blue line in the figure below Then loosen the auxiliary slider tightening screw the red circle position in the figure below then slide down and down according to the blue arrow direction to adjust the slider align the scale line on the slider the yellow circle above to the distance you actually need tighten the tightening screw to fix the slider and then proceed to the following steps Hold the three eyed pulley in front and back of your finger and insert it into the fixing groove of the pulley of the auxiliary device from the side It does not need to be too tight as long as the pulley does not loosen and fall as shown in the following figure it should be noted that the upper and lower sides of the fixing groove of the pulley must