TMC2208 V1.0 Stepper Motor Driver + Tester Module With Stackable Headers Test Or Flash Parameter Modes Of TMC2208 Operation On USB To Serial Adapter For 3D Printer

Description: With this adapter you can test your SilentStepStick or flash the TMC2208 SilentStepStick with an USB-to-serial converter. The adapter comes with stackable headers, so you can use it direct on your 3D printer board The tester is pre-configured for standalone operation on an USB to serial adapter (VIO-VM jumper closed). With the TMC2208 Configurator you can change the settings and program the OTP (One-Time-Programmable) memory of a Trinamic TMC2208 via the UART interface. TMC2208: Hardware compatible with StepStick and Pololu A4988 Drive capability up to 1.2A (RMS) continuous coil current - 2A Peak Step/Dir interface with microstep interpolation (up to 256 microsteps) Configuration via CFG pins or UART interface Motor supply voltage: 5.5...36V Logic supply voltage: 3.3...5V Components on the bottom for better heat dissipation stealthChop2 - for quiet operation and smooth motion (default setting) spreadCycle - highly dynamic motor control chopper (enableable via UART) To run the program: -Install ScriptCommunicator -Download TMC2208.scez -Start the TMC2208.scez file with the ScriptCommunicator: ScriptCommunicator TMC2208.scez -Choose the right serial port and click Connect -Modifications in the Configurator are directly transmitted Notes: The OTP bits can be programmed only one time. If you enable spreadCycle then TOFF cannot be 0 (null). Package Included: 1x Tester module 1x TMC2208 V1.0 Stepper Motor Driver 1x Heatsink 1x USB cable 1x Screwdriver