Stable 600W Low Temperature System Treatment Machine Rubber For Polymers Silica Gel Metals EU Plug

Stable 600W Low Temperature System Treatment Machine Rubber for Polymers Silica Gel Metals EU Plug Specification: Item Type: Treatment MachineInput Power: AC220V 50HZ Spray Diameter: Approx. 42mm / 1.7in Maximum Power: 600W Nozzle Processing Width: Approx. 8 ~ 12mm / 0.3 ~ 0.5in Frequency: 50Hz Input Air Pressure: Greater than or equal to 0.2Mpa Output Working Pressure: Greater than or equal to 0.1Mpa High Voltage Line Length: Approx. 2meter / 6.6ft Operating Temperature Range: -10 degrees Celsius ～+50 degrees Celsius Note: 1. The equipment is a special equipment. Personnel without professional knowledge should not open the case to maintain the equipment 2. The ground terminal of the host must be reliably connected to the earth ground 3. The high-voltage cable routing between the nozzle and the host should be natural and not bend at a large angle; 4. Pay attention to the protection of high-voltage cables to prevent sharping objects from scratching the insulation layer of high-voltage cables; 5. The human body should not touching the jetted inner flame. 6. The external control interface prohibits voltage input. 7. When the machine is working the air source must be water-free and oil-free compressed air and the bad air source will cause damage to the nozzle. 8. If there is no air or the air is insufficient the equipment will automatically shut down for protection. 9. Please use the middle orange area for the low-temperature flame sprayed by the nozzle that is the area from 8mm to 12mm from the nozzle. 10. It is strictly forbidden to use it in a flammable and explosive gas environment. Package List: 1 x Treatment Machine 1 x High Voltage Line 1 x User Manual