RFID NFC Expansion Board IC Card Sensor Module With 13.56Mhz RF Card Duinopeak for Arduino - products that work with off

Feature The easiest to use RFID NFC PN532 Shield IC card expansion board can be used in Serial module radio frequency IC card sensor electronic building blocksEasy to use easy to connect cost effective serial RFID radio module RFID radio frequency identification is a non contact object recognition technology it can automatically Identify the target through the RF signal and access to relevant data so many interactive projects is to borrow this feature to achieve the identification of objects The perfect tool for any 13 56MHz RFID or NFC application This shield is designed to use I2C or SPI communication protocols I2C is the default as it uses fewer pins analog 4 and 5 are used for I2C of course you can still connect other I2C devices to the bus Digital 2 is Used to interrupt notification This means you do not have to sit there and poll the chip to ask if a target tag has been found the pin will pull low when a card phone etc is within range You Can adjust which pin is used if you need to keep digital 2 for something else It is also easy to change the shield over to SPI where you can use any 4 digital pins by shorting two solder jumpers on the top of the PCB Compatible with the use of the I2C interface with Mega R2 or earlier two wires must be soldered as the I2C pins are in a different location on earlier 2 with any classic NG Diecimilla Duemilanove UNO as well as Mega R3 or later Package includes 1 xRFID RF expansion board1 x RF card