Multi-function Adjustable Signal Generator 2-10V Signal GeneratorSine Wave 4-20mA PWM Pulse Signal Source Support RS48

Descriptions Notes This module is divided into two versions the signal generator and the version with MODBUS function The difference is that the power supply with MODBUS version has RS485 communication interface which can be set or data collected by the host computer software or with the computer PLC DCS smart meters and other equipment for communication Other than that the other features are the same Restore factory settings when power off press and hold P1 then power on and then release the button it will be restored Calibration function The module source mode has voltage and current calibration function If there is any display error it can be calibrated by the following methods First power off press and hold the code switch to power on it will enter the calibration voltage and current mode use the multimeter output voltage quantity GND and 2 10V or current quantity GND and 4 20MA rotate and adjust to display consistent with the multimeter After three seconds the power can be cut off and the accuracy can be corrected to less than 0 1 Specifications Supply voltage 7 12VProduct features PWM mode pulse mode source mode sine wave modePWM mode voltage frequency duty cycle are adjustable the accuracy is up to 0 1 voltage range 1 24V frequency range 1 150KHZ duty cycle range 0 100 Pulse mode start delay time T0 0 60S high time time T1 0 60S low time time T2 0 60S pulse number PulseNun 1 60000 accuracy 0 001SSignal source