M5CameraX ESP32 Camera Development Board Module Mini OV2640 Camera Unit Demoboard with PSRAM GROVE Port TypeC M5Stack® for Arduino - products that work with official Arduino boards

Description: M5CameraX is a development board for image recognition. It features an ESP32(4M Flash + 520K RAM) chip and 2-Megapixel carmera(OV2640).M5Camera offers plenty of storage, with an extra 4 Mbyte PSRAM. It also supports image transmission via Wi-Fi and debuging through USB Type-C port. The hardware comes preloaded software, programmed by ESPIDF. It is an application to run Wi-Fi camera. The output image is size 600*800, since it's 2-Maga camera, you sure can optimize the software to output the maximum size of photos. what this software can do? Power the board via USB type-C or GROVE Use your phone to Wi-Fi scan an AP name start with 'm5stack-' and click to connect this AP. Open up web browser on your phone and visit 192.168.4.1 Then here comes the picture. Video is about 5-6 frames per senconds. not super fast. The hardware also comes with some reserved weld pad, just in case you want put these chips back on board. 9-ax is gyroscope (MPU6050) pressure sensor (BME280) Analog MIC (SPQ2410) Lipo Battery power pins Product Features: ESP32 specifications Dual-core Tensilica LX6 microprocessor Up to 240MHz clock frequency 4MB PSRAM 4MB Flash memory Integrated 802.11 BGN WiFi transceiver Integrated dual-mode Bluetooth Hardware accelerated encryption (AES, SHA2, ECC, RSA-4096) CP2104 USB-to-TTL converter ESP32-WROVER (PCB Antenna) OV2640 sensor Output Formats(8-bit): YUV(422/420)/YCbCr422 RGB565/555 8-bit compressed data 8-/10-bit Raw RGB data Maximum Image Transfer Rate according to specific format UXGA/SXGA: 15fps SVGA: 30fps CIF: 60fps Scan Mode: Progressive Camera specifications CCD size : 1/4 inch Field of View : 65 degree Maxmium Pixel: 2M Sensor best resolution: 1600 * 1200 Dimension: 40 49 13mm Package Included: 1x M5CameraX 1x Wall-1515 1x Type-C USB Cable EasyLoader click to download EasyLoader 2.After downloading the software, double-click to run the application, connect the M5 device to the computer via the data cable, select the port parameters, and click "Burn" to start burning. 3.The CP210X (USB driver) needs to be installed before the EasyLoader is burned. Click here to view the driver installation tutorial PinMap: Camera Interface PinMap Interface Camera Pin M5Camera(A model) M5Camera(B model) SCCB Clock SIOC IO23 IO23 SCCB Data SIOD IO25 IO22 System Clock XCLK IO27 IO27 Vertical Sync VSYNC IO22 IO25 Horizontal Reference HREF IO26 IO26 Pixel Clock PCLK IO21 IO21