Jonsbo M.2-3 Solid State Radiator For NVME/SSD(Grey)

1. Material: aluminum2. Heat dissipation method: drainage passive heat dissipation3. With high-quality thermal silica gel, quickly conduct heat to avoid overheating and slowing down4. Suitable for M.2 2280g solid state drive5. Anode sandblasting process, anti-corrosion and anti-rust, not easy to get dirty6. Diversion type upper heat sink, solid state drive (not included)7. The heat sink under the shell, the overall heat dissipation effect is good8. Striped lines at the bottom increase the heat dissipation area and quickly take away heat9. Dimensions: 24.4x7.3x6.9 cm10. Weight: about 80 gramsinstallation steps:1. Tear off the thermal pad film and stick it in the bottom card slot2. Put the SSD PCB into the card slot with the chip facing up3. Adjust the position of the PCB to reveal the golden fingers and screw holes4. Stick a thermal pad on the inside of the top fin (tear off the film)5. After jamming one side of the card slot, press to fix it6. If you need to disassemble, slide your fingernail along the seam to open it7. Insert the motherboard slot8. Fix the hard drive screws (included with the motherboard)9. Installation is complete