Holybro PM02 V3 Power Module 12S Power Distribution Board forAPM Pix32 Pixhawk4 Flight Controller

PM02 Power Module is a simple way of providing your autopilot flight controller with clean power from a LiPo battery as well as current consumption and battery voltage measurements all through a 6 pos cable The on board switching regulator outputs 5 2V and a maximum of 3A from up to a 12S LiPo battery The Power Module comes completely assembled with XT60 connectors and wrapped in shrink tubing for protection The Power Module is designed to power autopilot flight controller a RC receiver and APM accessories GPS radio It is not designed to power servos Use your aircraft s own ESC BEC for that The GH terminal is also compatible with Pix32 Pixhawk4 Pixhawk4 mini Pix32v5 and Durandal Note This PM02 Power Module uses analog data output and is not compatible to the Pixhawk 5X Requires a digital PM like PM02D Spec Manual UBEC input voltage 7 51v 2 12s LiPo Rated current 60AMax current 120A 60S Max current sensing 120ASupports 12S batteryVoltage and current measurement configured for 3 3V ADC Switching regulator outputs 5 2V and 3A max Weight 20gMake the PM02 show the quantity of electric charge of your batteryMission Planner setup Connect PM02 to the battery also connect it to Mission Planner via USB Click INITIAL SETUP and come to the menu Battery Monitor Make Monito into Analog Voltage and Current Make Sensor into 9 Holybro Pixhawk4 PM Make HW Ver The Cube or Pixhawk pixhawk4 pixhawk4mini pix32v5 pix32 HW Ver Durandal Dur