GABBU SALES SMART CHOICE IMMERSION WATER HEATER 2000 Immersion Heater Rod(WATER)

THE HEATER IS PROVIDED IN 3CORE CABLE. WHERE GREEN IS FOR EARTH. IT IS IMPERATIVE THAT THE HEATER SHOULD BE CONNECTED TO A 3 PIN SOCKET WITH PROPER EARTHING.IT IS RISKY TO USE THE HEATER WITHOUT PROPER EARTHING. THE HEATER SHOULD BE CONNECTED TO MAIN ONLY AFTER IT IS DIPPED IN WATER. THE IMMERSION HEATER SHOULD BE IMMERSED IN WATER WHOSE LEVEL WILL BE IN B/W THE MINIMUM AND MAXIMUM LEVEL INDICATES ON THE STRIP. IF THE LEVEL OF WATER LOWER THAN THE MINIMUM MARK THEN THE ELEMENT WILL BE BURNT OUT DUE TO DRY HEAT. IF THE LEVEL OF WATER IS HIGHER THAN THE MAXIMUM LEVEL MARK THEN THE WATER WILL BE ENTER INTO THE BAKELITE CONNECTOR & SHORT CIRCUIT.THE CURRENT SHOULD BE SWICTHED OFF & PLUG TOP REMOVE FROM THE SUPPLY BEFORE THE HEATER IS TAKEN OUT OF THE WATER. PLEASE KEEP THE HEATER IN THE WATER FOR A MINUTE OR TWO AFTER SWITCHING OFF THE PLUG.THE IMMERSION HEATER IS MEAN FOR HEATING WATER ONLY IS NOT RECOMMENDED FOR USE IN OTHER LIQUID SUCH AS MILKAS THAT WOULD HAVE CORROSIVE EFFECT ON THE HEATER. DO NOT BRING THE IMMERSION FACTOR IN CONTACT WITH ANU COMBUSTIBLE MATERIEL IMMEDIATELY AFTER ITS WIDHRAWL FROM WATER.DON'T DIP BAKELITECONNECTOR IN THE WATER. THE VESSEL SHOULD BE DEEP NOT LESS THAN 175MM & IT SHALL BE POSSIBLE TO HANG THE IMMERSION HEATER WITH THE HELP OF HOOK. USE ONLY METEL VESSELFOR PROPER EARTHING.