Feoflen LCD Display Solar Charge Controller Solar Panel Battery Intelligent Regulator Solar Charge Controller Solar Panel Battery Intelligent Regulator With Dual USB Port 12V/24V PWM Auto Paremeter Ad

Specification: Item Type: Solar Charge Controller Material: Shell Plastic + Back Plate Iron Product Color: Black Total Length: Approx. 13.3cm / 5.2in Total Width: Approx. 7cm / 2.8in Total Width: Approx. 3.2cm / 1.3in Display Length: Approx. 12.6cm / 5.0in Display Width: Approx. 5cm / 2.0in Product Weight: Approx. 157g / 5.5oz Display Mode: LCD Screen Voltage: 12V / 24V Automatic Identification Applicable Solar Panels: 12V is suitable for 18V solar panels 24V is suitable for 36V solar panels Maximum Photovoltaic Voltage: 12V battery up to 23V; 24V battery up to 46V up to 50V under no load Full Cut Off Voltage: 14.4 / 28.8V Discharge Cut Off Voltage: 10.7 / 21.4V Discharge Recovery Voltage: 12.6 / 25.2V Charging Recovery Voltage: 13.2V / 26.4V Light Controlled Turn On Threshold: Solar Panel 8V light on delay Light-controlled Turn Off Threshold: Solar Panel 8V light on delay Standby Current: ＜10MA USB Output: Dual USB Output 5V / 2.5A（） Working Temperature: -35℃ to 60℃ Package List: 1 x Controller 1 x Manual Note: 1. This controller is 12V/24V automatic identification. When installing for the first time please make sure that the battery has enough voltage so that the controller can recognize the correct battery type. In order to the service life of the battery once the battery voltage is lower than 8V the solar controller will automatically shut down. 2. Install the controller as close to the battery as possible to avoid voltage drop caused by excessively long wires and affect normal voltage judgment. 3. This controller is only suitable for various VRLA batteries including openings gels etc. please do not use it for other batteries including lithium battery NI‑MH battery etc.. 4. This controller can only use photovoltaic panels as the charging source. Do not use DC or other power sources as the charging source. 5. The controller will generate heat when it is running. The operating temperature of the controller is ‑35°C to +60°C. Please be careful to install the controller on a flat well‑ventilated . 6. The LCD display of this controller has an error of 0.2V‑0.3V but this is normal. How to use: 1. First connect the battery to the positive and negative of the charge regulator. 2. Then connect the photovoltaic module to the positive and negative signs of the regulator. 3. Finally connect the user to the positive and negative of the regulator.