3D Printer Mainboard Kit RAMPS 1.4 + Arduino Mega 2560 + DRV8825 + 12864LCD + PCB Heat Bed MK2B

Introduction: The DRV8825 stepper motor driver carrier board TI DRV8825 micro bipolar stepper motor drive is a breakthrough. the module pinout and interface with our A4988 stepper motor driver carrier is almost the same, so it may be a better performance from the pull-down menu board replacement in many applications. DRV8825 features an adjustable current limit, overcurrent and overheating protection, six micron resolution (down 1/32-step). the use 8.2-45 V, up to 1.5 per Arduino stage no heatsink or forced airflow (nominal to 2.2 per volume sufficient additional cooling). Features: 1. Simple steps and direction control interfaceStep 2. Six different resolutions: full step, half step, 1/4-step1 / 8-step1/ 16-step, 1/32-step 3.CAN interfaces directly with 3.3 V and 5 V systems 4.The over-temperature thermal shutdown, overcurrent shutdown,undervoltage lockout 5. Short-to-ground short circuit load protection 6.4 Layer 2 oz copper PCB, to improve the heat dissipation 7. bottom bare welding ground following a driver IC on a printed circuit board pad 8. The module size, pins and interface matching A4988 stepper motor driver carrier in many ways 9.The adjustable current control allows you to set a potentiometer, which lets you use the stepper motor's rated voltage or more,in order to achieve a higher maximum output current step rate 10. Intelligent chopping control automatically selects the correct current decay mode (fast or slow decay attenuation) 11. The maximum 45 V supply voltage 12. Built-in voltage regulator (the need for any external logic supply voltage) Pay attention to the direction when installation stepper motor drives Package included: 1 x Mega 2560 R3 1 x Ramps 1.4 1 x USB line 5 x DRV8825 module with heatsink 1 x PCB Heatbed MK2B 1 x 12864LCD control panel 1 x Adapter 2 X Cable