1PC APM PIX Flight Controller Power Module XT60/T Plug Voltage Current Sensor with 2A 5V BEC Parts for RC FPV Drone Mode

Specification Voltage galvanometer Power meter with 5V 2A BEC flight control power supply module is used to detect battery voltage and battery current the flight control board receives these two signals calculates the remaining battery power and estimates the remaining flight time Function Used to detect battery voltage and battery current The flight control board receives these two signals calculates the remaining battery power and estimates the remaining flight time In addition this module also has BEC function which can output 5 3V DC and maximum 3A continuous current to provide stable power for the flight control board In addition the signal cable connectors are made of Japanese original connectors non domestic connectors so that the APM flight control board and the power module are reliably connected The maximum input voltage is 25V and the maximum current can be measured at 90A which enables the control panel to monitor battery power and voltage The design parameters of the voltage and current detection are consistent with the official 3DR design parameters The setting of the ground plan mission planer can refer directly to the official wiki settings Please APM flight controllers pay attention to the flight control power supply is best powered from the PM port because the flight control board circuit has a power supply reverse voltage protection diode and a fuse this protection circuit only works when the power supply is connected from the PM por