Ledander Wi-Fi Intelligent LEDs Strips Lights 16.4ft 5050RGB Color Changing Rope Light IP65Water-resistant Compatible with / Home/Ehco for Home Party Decoration Restaurant KTV

Product Details: Product Name: 2835 RGB Color Changing Light Strip - 16.4ft [Multiple Scenes Available]: LED strips can be used anywhere you want to create an amazing atmosphere. Decorate bedroom kitchen dining room or bookcases closets. Great for Christmas holiday party decorations and other holidays. [Multi-color and multi-mode]: This remote control light has 20 colors and 6 lighting modes you can easily choose the color you want and you can DIY the color ratio through the remote control to create your own special decoration style. 【Function-rich adjustable brightness】: The brightness and flashing speed can also be adjusted whether it is a stimulating atmosphere or a relaxing atmosphere it can be perfectly realized. [Easy to install]: The back of the light bar is super glue tear it off and stick it where it needs to be decorated keep the installation surface clean dry and flat before installation 【Cutable & DIY Length】: The 16.4ft LED light bar is long enough to cover the whole room and illuminate the whole place the light bar can be cut allowing you to choose the length of the LED light according to your needs 【Material safety and environmental protection】: The light bar has low heat generation and good heat dissipation which can prolong the service life. The light bar is safe without radiation and will not harm human eyes. Children can also touch very safe. How to use the DIY function: Step 1: Start the DIY function. - turn on the light; - press one of the RGB buttons; - press the DIY1 button (take DIY1 as an example); - press the first button in the first row Step 2: DIY setup. Press and hold the red up arrow or down arrow button to increase or decrease the red scale (press and hold for 5 seconds or more). Adjust the ratio of green and blue in the same way DIY your favorite color Step 3: Press the DIY1 button again to keep the color you just set. Repeat the above steps to set up the remaining five DIYs notes: 1. Please make sure that the → arrow mark (on the female connector) and the → arrow mark (on the light bar) are on the same side. Otherwise the bar light will not work. Please unplug rotate and reinsert 2. Please pull out the transparent chip before using the infrared remote control. When using the infrared remote control aim at the infrared receiver 3. Every 3 LED lights is a complete light-emitting module the light strip has been marked with a cuttable mark the cut light strip needs a power adapter to light the rest of the light strips please cut carefully and make sure that the part you leave is connected to energized components. 4. Do not roll up when using pack: 1 roll waterproof 5 meters + 1A plug + remote control + single head adapter