X3 5.5 Inch Screen ELM327 OBD2 Bluetooth Version Car Head Up Display HUD

X3 ELM327 Bluetooth Version Car Head-up Display HUD Description: 1.Plug and play. HUD can automatically adapt to vehicle type which in line with OBDII or EUOBD(On-Board Diagnostic System).2.Comprehensive display. HUD can display many parameters at the same time as follows, vehicle speed, engine speed, water temperature (voltage, throttle valve position, ignition advance angle, time of 100 km acceleration),fuel consumption, mileage, low fuel tips, engine failure.3.Three display mode. Driver can chose normal display mode, high- speed display mode and automatic display mode.4.Free switch. Km and mile can be switched freely.5.Suitable size. The display area is 5.5 inches which is very clear for driver to read data.6.Automatic power on and off. Starting with the vehicle starting, stopping with the vehicle stopping to protect the vehicle’s battery. Moreover, HUD can also power on and power off by manual, which is more easy to control HUD. 7.Flexible alarm mode. HUD can offer single-stage and four-stage overspeed alarm modes to choose to make driving safer.8.Engine speed alarm. It contributes to shift gear in time to save fuel also has significance to new driver.9.Flexible brightness adjustment. The brightness can be adjusted automatically or manually to reach the best state which is in harmony with the environment. Main Technical Indicators1. Service conditions: Environment temperature: -400C—+800C Barometric press: 86—106 KPa Relative humidity: 10%—95% Environment voice: =30dB(A)3. Work voltage: 9V~16Vdc(12Vdc/400mA)4. Size of product: 150*85*14 (mm)5. Weight of product: 278g HUD installation1 Know the type of your vehicle. When purchasing HUD, you need to choose the type of vehicle that meets the OBDII standards (or EU OBD) for normal use. Open the engine hood and find the sticker below it (see the below picture 1), if it has words like OBDII CERTIFIED, then it can be installed. 2 Find out the 16 pin diagnostic link of the vehicle and connect it well with OBDII connecting line. 3.Put non-slip mat in flat position in front of the dashboard, you can adjust the angle of the HUD on it.4.Paste the reflective film above the HUD in order to display the whole information of HUD.5.Test the power, you need to turn on the HUD and you will see vehicle’s recent voltage, and then enter into the state of scanning vehicle’s OBD protocol, if the HUD shows fuel consumption, speed, rotating speed, indicating that HUD has been installed successfully. Instructions: This HUD built in ELM327 and with bluetooth version function. Not only you can use the HUD to read all the information on windowscreen, but also you can download OBD APP from Android phone to read more information.Package Included:1 X Car Head-up Display HUDProduct Details: